JBA 00-06 Chevrolet Avalanche/Suburban 6.0L/8.1L 409SS Pass Side Single Exit - 40-3016Find parts that fit my vehicle

Jba Exhaust install,

After an inventory of parts. Got the truck raised up and Jack stands in place. Started to pull out old system. Little hesitant to cut the pipe but after laying out the new exhaust system insuring it would fit I went at it and pulled the stock system. The new pipes/muffler went together in about a half hour. I was greatful for the quality and fit of the JBA Exhaust. After reattaching the battery, nice tone. (Monday in two days) My cold air K&N arrives.

nice enough but not loud at all

piping is good quality but it is just barely louder than stock. if just a need an ok replacement for stock, this will work. if you want performance and a good sounding truck, go with something else

Confusion

So from the photos from another buyer, with this exhaust it loses a hanger in the middle and has cab vibration when at a stop, any way to fix it? Though I am happy not having a trash leaky exhaust I want it to not vibrate my cab, thanks.

Not very loud

Fairly easy to install, not as loud as I had hoped it would be

JBA 5.0L Cat-back Exhaust

The first review, well all-in-all this system is good. I do have a few complaints… it drones A LOT at low speeds, i.e. in residential neighborhoods, or slower speed limits (25 mph). This drone is extremely annoying and causing headaches if travel is significant at these speeds. There is still some drone when at highway speeds, though it is hardly noticeable if you have music on. This system does a great job of deepening the exhaust note. I also have not noticed a decrease in my fuel efficiency, which is always a good thing. I did have some issues with the install when attempting to fit all of the pieces to the exhaust together. I had to manually bend the female aspect of each respective part to then fit the pieces together. Other than that, the install was smooth and easy, only took about 1 hour by myself with a regular 3 ton jack for removal of stock system and install of the JBA system.

Solid purchase

Well I’m happy so far, only thing I could say is it’s not as loud as I thought it would be but it’s definitely got a nice deep rumble.

GREAT PRODUCT

Adds a great sound to your Bronco. Was easy to install took only 35 minutes.

Perfect tone

Love the sound being a 3.3 V6 doesn't sound like a 6

JBA single exit muffler dual exit tip

This was a very easy install look at the install instructions carefully it all mounts just as it should. If they would let me post a video I would. There doesn’t appear to be one online

Sounds great

Good look, sounds great at a good price. Needed some minor modifications to install. Had to use a swedge on some of the pipe opening. Had to slot the rear of the muffler pipe to get the clamp to tighten enough to hold. Also the rear muffler hanger was too tight, had to drill out some of the rubber in the hanger. Took about an hour and a half to install.