SPC GM OFFSET UPPER BALLJOINT - 23960Find parts that fit my vehicle

These heavy duty offset ball joints have a built in 3 degree offset which can be clocked to affect camber, caster, or both. They are ideal for vehicles which cannot be aligned properly with the factory cam bolts due to installation of a lift or levelingkit. As an additional benefit, they also raise the outer end of the upper control arm, which increases clearance between the arm and the droop travel stops on the frame. This restores droop travel on trucks with leveling kits, and eliminates noise vibration harshness caused by arm to frame contact. Note: Due to strength limitations of the factory upper control arm, this ball joint should not be used on trucks with tires larger than 33" unless a "tall knuckle" lift kit is installed. SPC uses hex chromate free finish and offers a 700hr salt spray test for the best corrosion protection available. California Residents WARNING

Suspension components are key to making sure your car is riding smoothly on or off the road. With upgraded suspension components, you can unlock the full potential of your vehicles performance.

Ball joints are a vital component of your vehicle's suspension. Overtime, ball joints wear out and will need to be replaced. It is important to replace your ball joints because ball joint failure could lead to a catastrophic accident.

CA Residents: WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov